01 / 20

Parenteral Medication
Administration

Mastering the routes, angles, and safety steps for delivering medications by injection as a practical nurse.

NCLEX-PN

What Is Parenteral?

The word parenteral means "outside the intestine." It refers to any route of giving medication that bypasses the digestive tract, most commonly by injection through a needle.

The Four Main Routes

ID
Intradermal: into the dermis layer, just below the surface.
SubQ
Subcutaneous: into the fatty tissue under the skin.
IM
Intramuscular: deep into muscle tissue.
IV
Intravenous: directly into a vein and bloodstream.

Injection Angles

Dermis Fatty tissue Muscle ID 15° SubQ 45° IM 90°

The Core Rule: The Rights

Before any injection, the nurse must verify the Rights of Medication Administration. These checks prevent errors when a drug cannot be retrieved once injected.

1
Right Patient — verify two identifiers.
2
Right Medication — match drug to order.
3
Right Dose — confirm correct amount.
4
Right Route — ID, SubQ, IM, or IV.
5
Right Time — administer within the schedule.

The Dosage Formula

To calculate how much volume to draw up, use the classic "desired over have" formula:

SubQ vs IM

SubQIM
TissueFatty layerMuscle
Angle45° or 90°90°
Needle gauge25–27 G20–23 G
Max volume\( \leq 1 \text{ mL} \)\( 1{-}3 \text{ mL} \)
Common useInsulin, heparinVaccines, antibiotics

How to Apply It

1
Verify the order and perform hand hygiene.
2
Calculate the dose using \( \frac{D}{H} \times Q \).
3
Select the site and the correct needle length and gauge.
4
Clean the site and insert at the correct angle.
5
Inject, withdraw, and document the medication given.

Worked Example: Insulin

A client needs 12 units of regular insulin subcutaneously. The vial is labeled \( 100 \text{ units/mL} \). What volume do you draw?

Worked Example: IM Antibiotic

Order: 500 mg of an antibiotic IM. The vial reads \( 250 \text{ mg per } 1 \text{ mL} \). Calculate the volume.

Worked Example: TB Test

A PPD (tuberculin) test requires 0.1 mL injected intradermally into the inner forearm. Describe the correct technique.

Common Mistakes

✕ Wrong Angle
Using 90° for an ID injection deposits drug in fat, not the dermis.
✕ Massaging Heparin
Rubbing a SubQ anticoagulant site causes bruising and bleeding.
✕ Skipping Identifiers
Failing to verify two patient identifiers risks a wrong-patient error.
✕ Volume Too Large
Giving more than 1 mL SubQ causes pain and poor absorption.

Route Summary

RouteAngleVolumeAspirate?
Intradermal15°\( 0.1 \text{ mL} \)No
Subcutaneous45°/90°\( \leq 1 \text{ mL} \)No
Intramuscular90°\( 1{-}3 \text{ mL} \)Usually no
Intravenousn/aVariesn/a

Key Takeaway

Question 1 of 5

At what angle should an intradermal injection be given?

Question 2 of 5

Order: \( 75 \text{ mg} \). Supply: \( 25 \text{ mg per } 1 \text{ mL} \). How many mL do you give?

Question 3 of 5

Which route delivers medication into the fatty tissue below the skin?

Question 4 of 5

After a subcutaneous heparin injection, the nurse should:

Question 5 of 5

What is the maximum recommended volume for a subcutaneous injection?

You're Ready to Inject Safely