01 / 21

Circuit Elements &
Ohm's Law

Master the fundamentals of voltage, current, and resistance in electrical circuits: the building blocks for MCAT physics.

MCAT Physics

What is an Electrical Circuit?

An electrical circuit is a closed loop that provides a path for electric charge to flow. Every circuit requires three essential components: a source of EMF (like a battery), conducting wires, and a load (like a resistor or lightbulb).

+ - Battery Resistor \(I\) Conducting Wire

Three Fundamental Quantities

Voltage \(V\)
The electric potential difference that drives charge through a circuit. Measured in volts (V). Think of it as electrical "pressure."
Current \(I\)
The rate of charge flow: \(I = \frac{\Delta Q}{\Delta t}\). Measured in amperes (A). Think of it as electrical "flow rate."
Resistance \(R\)
Opposition to current flow. Measured in ohms (\(\Omega\)). Think of it as a "bottleneck" restricting flow.

EMF and Internal Resistance

The electromotive force (EMF), denoted \(\varepsilon\), is the voltage a battery provides when no current flows. Real batteries have internal resistance \(r\), so the terminal voltage is always less than the EMF when current flows:

Real Battery \(\varepsilon\) \(r\) \(R\) + - Load

Ohm's Law: The Core Equation

\(V\) \(I\) \(R\) Cover the unknown: what remains is the formula
Find \(V\)
\(V = I \times R\)
Find \(I\)
\(I = \frac{V}{R}\)
Find \(R\)
\(R = \frac{V}{I}\)

Resistance and Resistivity

Resistance depends on the material properties and geometry of the conductor. The relationship is:

Longer wire
\(R\) increases: more material for electrons to pass through.
Wider wire
\(R\) decreases: more "lanes" for current to flow.
Higher \(\rho\)
\(R\) increases: material intrinsically opposes flow more.

Series vs Parallel Resistors

Series Parallel
Configuration End to end (one path) Side by side (multiple paths)
Current Same through all Splits among branches
Voltage Splits across each Same across all
Equivalent \(R\) \(R_{eq} = R_1 + R_2 + \ldots\) \(\frac{1}{R_{eq}} = \frac{1}{R_1} + \frac{1}{R_2} + \ldots\)
Effect on total \(R\) Increases Decreases

Visualizing Series and Parallel

Series Circuit \(R_1\) \(R_2\) \(I\) \(R_{eq} = R_1 + R_2\) Parallel Circuit \(R_1\) \(R_2\) \(I_1\) \(I_2\) \(\frac{1}{R_{eq}} = \frac{1}{R_1} + \frac{1}{R_2}\)

Power Dissipation in Circuits

Electrical power is the rate at which energy is delivered or consumed. Resistors dissipate power as heat (Joule heating). There are three equivalent forms:

\(P = IV\)
Power equals current times voltage. The most general form.
\(P = I^2 R\)
Substitute \(V = IR\). Use when current and resistance are known.
\(P = \frac{V^2}{R}\)
Substitute \(I = V/R\). Use when voltage and resistance are known.

Kirchhoff's Circuit Laws

1
Junction Rule (KCL): The total current entering a junction equals the total current leaving it. This is conservation of charge: \(\sum I_{\text{in}} = \sum I_{\text{out}}\).
2
Loop Rule (KVL): The sum of all voltage changes around any closed loop is zero. This is conservation of energy: \(\sum \Delta V = 0\).

How to Solve a Circuit Problem

1
Draw the circuit. Label all resistors, batteries, and unknown quantities.
2
Simplify resistors. Combine series and parallel groups to find \(R_{eq}\).
3
Find total current. Use \(I = \frac{V}{R_{eq}}\) with the source voltage.
4
Work backwards. Use Ohm's Law to find voltage drops and branch currents for each element.
5
Check with Kirchhoff's Laws. Verify: voltages sum to zero around loops, currents balance at junctions.

Example 1: Simple Series Circuit

\(12\text{ V}\) \(4\,\Omega\) \(2\,\Omega\) \(I = ?\)

Example 2: Parallel Resistors

Two resistors, \(R_1 = 6\,\Omega\) and \(R_2 = 3\,\Omega\), are connected in parallel across a \(12\text{ V}\) battery. Find \(R_{eq}\), total current, and branch currents.

Example 3: Combination Circuit

\(24\text{ V}\) \(4\,\Omega\) \(R_1\) \(6\,\Omega\) \(R_2\) \(12\,\Omega\) \(R_3\)

Common Mistakes to Avoid

✕ Adding parallel \(R\) directly
You must add reciprocals for parallel: use \(\frac{1}{R_{eq}}\), not \(R_{eq} = R_1 + R_2\).
✕ Confusing \(V\) and \(\varepsilon\)
Terminal voltage \(V = \varepsilon - Ir\) is less than EMF when current flows. They are equal only at \(I = 0\).
✕ Wrong power formula
Using \(P = I^2 R\) when voltage is the given quantity. Match the formula to known variables.

Key Formulas Summary

Concept Formula Units
Ohm's Law \(V = IR\) V, A, \(\Omega\)
Resistance \(R = \frac{\rho L}{A}\) \(\Omega\), \(\Omega \cdot m\), m, m\(^2\)
Series \(R\) \(R_{eq} = R_1 + R_2 + \ldots\) \(\Omega\)
Parallel \(R\) \(\frac{1}{R_{eq}} = \frac{1}{R_1} + \frac{1}{R_2} + \ldots\) \(\Omega\)
Power \(P = IV = I^2R = \frac{V^2}{R}\) W
Terminal Voltage \(V = \varepsilon - Ir\) V

Question 1 of 5

A \(9\text{ V}\) battery is connected to a single \(3\,\Omega\) resistor. What is the current through the circuit?

Question 2 of 5

Two resistors, \(R_1 = 4\,\Omega\) and \(R_2 = 12\,\Omega\), are connected in parallel. What is \(R_{eq}\)?

Question 3 of 5

A wire's length is doubled while its cross-sectional area is halved. By what factor does its resistance change?

Question 4 of 5

A \(10\text{ V}\) source drives \(2\text{ A}\) through a resistor. How much power does the resistor dissipate?

Question 5 of 5

A battery with \(\varepsilon = 12\text{ V}\) and internal resistance \(r = 2\,\Omega\) is connected to an external \(4\,\Omega\) resistor. What is the terminal voltage?