01 / 22

Coupled
Mass-Spring Systems

Explore how two masses connected by springs interact through coupled differential equations, and discover the elegant physics of normal modes.

Differential Equations

What Is a Coupled System?

A coupled mass-spring system consists of two (or more) masses connected by springs so that the motion of each mass depends on the displacement of the other. Unlike a single mass on a spring, you cannot solve for one mass's motion without simultaneously considering the other.

\(m_1\)
\(m_2\)
\(k\)
\(k\)
\(k\)
\(x_1\)
\(x_2\)

Essential Vocabulary

Displacement
\(x_1(t)\) and \(x_2(t)\) measure each mass's position from its equilibrium.
Spring Constant
The spring constant \(k\) sets the stiffness of each spring. A larger \(k\) means a stronger restoring force.
Normal Mode
A pattern where all masses oscillate at the same frequency with fixed amplitude ratios.

Why Coupled Systems Matter

Coupled oscillators appear everywhere in science and engineering. Understanding the simple two-mass model gives you the mathematical framework for far more complex systems.

Molecules
Atoms in a molecule vibrate like coupled masses: IR spectroscopy exploits these normal modes.
Engineering
Buildings, bridges, and car suspensions are modeled as coupled spring-mass networks.
Electronics
Coupled LC circuits obey the same equations, with charge replacing displacement.

Equations of Motion

Apply Newton's second law to each mass in the symmetric wall–\(m_1\)–\(m_2\)–wall system with all springs equal to \(k\). The coupling spring exerts a force proportional to the relative displacement \(x_2 - x_1\).

The Matrix Formulation

Collect the equations into a compact matrix system. For the equal-mass, equal-spring case \(m_1 = m_2 = m\), all springs \(= k\):

Finding Normal Modes

Assume a solution of the form \(\mathbf{x}(t) = \mathbf{v}\cos(\omega t)\). Substituting into \(m\ddot{\mathbf{x}} = -K\mathbf{x}\) gives:

Symmetric vs. Antisymmetric Mode

Mode 1: Symmetric (in-phase)
\(m_1\)
\(m_2\)
\(\omega_1^2 = k/m\)
Coupling spring unstretched Mode 2: Antisymmetric (out-of-phase)
\(m_1\)
\(m_2\)
\(\omega_2^2 = 3k/m\)
Coupling spring maximally used

Single Spring vs. Coupled System

Single Spring Coupled System
Degrees of Freedom 1 2
ODE Type One 2nd-order ODE System of 2 coupled ODEs
Natural Frequencies 1 frequency: \(\omega_0\) 2 frequencies: \(\omega_1, \omega_2\)
Solution Method Direct: \(x = A\cos(\omega_0 t + \phi)\) Eigenvalue problem
Behavior Simple harmonic motion Superposition of normal modes

How to Solve a Coupled System

1
Write Newton's 2nd law for each mass. Identify all spring forces acting on each mass, noting signs carefully.
2
Assemble the matrix equation \(m\ddot{\mathbf{x}} = -K\mathbf{x}\). The stiffness matrix \(K\) encodes all coupling.
3
Solve the eigenvalue problem \(\det(K - \lambda I) = 0\) to find \(\omega_1^2\) and \(\omega_2^2\).
4
Find eigenvectors for each \(\omega\). These give the amplitude ratios of each normal mode.
5
Write the general solution as a superposition of modes: \(\mathbf{x}(t) = c_1\mathbf{v}_1\cos(\omega_1 t + \phi_1) + c_2\mathbf{v}_2\cos(\omega_2 t + \phi_2)\).
6
Apply initial conditions to determine the constants \(c_1, c_2, \phi_1, \phi_2\).

Example: Equal Masses & Springs

Consider two equal masses \(m\) in the symmetric wall–\(m_1\)–\(m_2\)–wall setup, with all three springs having constant \(k\). Find the normal-mode frequencies.

Solving the Characteristic Equation

Finding the Mode Shapes

Substitute each \(\lambda\) back into \((K - \lambda I)\mathbf{v} = \mathbf{0}\) to find the eigenvectors (mode shapes).

Mode 1 (\(\omega_1^2 = k/m\))
$$\mathbf{v}_1 = \begin{pmatrix} 1 \\ 1 \end{pmatrix}$$ Both masses move in the same direction with equal amplitude. The coupling spring is unstretched.
Mode 2 (\(\omega_2^2 = 3k/m\))
$$\mathbf{v}_2 = \begin{pmatrix} 1 \\ -1 \end{pmatrix}$$ Masses move in opposite directions with equal amplitude. The coupling spring is maximally stretched/compressed.

The General Solution

Energy Transfer and Beats

If you excite just one mass, the energy will transfer back and forth between the two masses. This energy exchange creates a "beats" pattern in the motion. The effect is most dramatic when \(\omega_1\) and \(\omega_2\) are close (e.g., with a weak coupling spring), but the principle applies to any coupled system.

\(t\)
\(x\)
\(x_1(t)\): beat pattern
beat period \(\approx \frac{2\pi}{\omega_2 - \omega_1}\)

Common Mistakes

✕ Wrong Sign on Coupling
The coupling force on \(m_1\) is \(+k(x_2 - x_1)\), not \(-k(x_2 - x_1)\). Mixing up signs produces a wrong stiffness matrix.
✕ Forgetting Newton's 3rd Law
The coupling term must appear with opposite signs in the two equations. If \(m_1\) sees \(+k(x_2 - x_1)\), then \(m_2\) sees \(-k(x_2 - x_1)\).
✕ Non-Symmetric \(K\) Matrix
The stiffness matrix must be symmetric (\(K = K^T\)). If yours isn't, you have a sign error in the force equations.

Summary of Key Results

Concept Formula / Fact
Equation of motion \(m\ddot{\mathbf{x}} = -K\mathbf{x}\)
Stiffness matrix (equal \(k\)) \(K = \begin{pmatrix} 2k & -k \\ -k & 2k \end{pmatrix}\)
Eigenvalue equation \(\det(K - \lambda I) = 0\)
Normal-mode frequencies \(\omega_1^2 = k/m,\; \omega_2^2 = 3k/m\)
General solution Superposition of eigenmodes
Beat frequency \(\omega_{\text{beat}} = \omega_2 - \omega_1\)

Question 1 of 5

Two equal masses are connected by three identical springs (wall–\(m_1\)–\(m_2\)–wall). How many normal modes does this system have?

Question 2 of 5

In the symmetric (in-phase) mode of the wall–\(m_1\)–\(m_2\)–wall system with equal masses and equal springs, what happens to the coupling spring connecting the two masses?

Question 3 of 5

For the symmetric wall–\(m_1\)–\(m_2\)–wall system with equal masses and all springs \(= k\), the stiffness matrix is:
\(K = \begin{pmatrix} 2k & -k \\ -k & 2k \end{pmatrix}\).
What is \(\text{tr}(K)\)?

Question 4 of 5

If the coupling spring constant is increased while the wall springs and masses stay the same, what happens to the antisymmetric mode frequency \(\omega_2\)?

Question 5 of 5

The stiffness matrix \(K\) of a coupled mass-spring system must be: