Metabolic Control Analysis, Rate-Limiting Steps - Biochemistry

  1. According to metabolic control analysis, how is control of flux usually distributed in a pathway?
    It is shared among several enzymes rather than resting entirely on one rate-limiting step.
  2. A three-enzyme pathway has flux control coefficients of 0.6 and 0.3 for two enzymes. What is the third's coefficient?
    0.1, because the coefficients must sum to 1.
  3. How can a substrate cycle (futile cycle) benefit metabolic control?
    Running opposing reactions at once amplifies the effect of a regulator on net flux, at a cost in ATP.
  4. An enzyme has a flux control coefficient of 0.8. Its activity is raised by 10 percent. About how much does flux change?
    About 8 percent (0.8×100.8 \times 10 percent), for a small change in activity.
  5. Why does overexpressing an enzyme with a flux control coefficient near zero barely change pathway flux?
    Flux is controlled by other steps, so raising that enzyme's activity has almost no effect on overall flux.
  6. What is a flux control coefficient?
    The fractional change in pathway flux divided by the fractional change in an enzyme's activity: C=dln⁡Jdln⁡EC = \frac{d \ln J}{d \ln E}.
  7. What does an elasticity coefficient measure?
    How sensitive the rate of one enzyme is to the concentration of a metabolite, such as its substrate or an effector.
  8. What is feedback inhibition?
    Inhibition of an early, usually committed, enzyme in a pathway by the pathway's end product.
  9. What does the summation theorem of metabolic control analysis state?
    The flux control coefficients of all enzymes in a pathway sum to 1.
  10. What is the committed step of a metabolic pathway?
    The first irreversible reaction unique to that pathway, after which the substrate is destined for the pathway's product.
  11. How do the mass-action ratio QQ and the equilibrium constant KK compare for a near-equilibrium reaction?
    QQ is close to KK, so the reaction runs readily in either direction and is a poor control point.
  12. What free energy property do regulated metabolic steps typically have?
    A large negative actual ΔG\Delta G, meaning they are far from equilibrium and their flux depends on enzyme activity.

Study these flashcards