Enzyme Assay Data - Biochemistry

  1. A crude extract has 1000 total units, and the purified fraction has 300 units. What is the percent yield?
    30%. Yield is total activity recovered divided by starting total activity.
  2. What is an enzyme unit (U)?
    The amount of enzyme that converts 1 μmol of substrate per minute under defined conditions.
  3. What is specific activity, and how does it change during a successful purification?
    Enzyme units per milligram of total protein. It rises as contaminating proteins are removed.
  4. As a common guideline, about what maximum fraction of substrate may be consumed for a measured rate to count as initial?
    About 10%. Beyond that, falling substrate and rising product make the progress curve bend.
  5. A fraction contains 200 units of enzyme activity in 4 mg of total protein. What is its specific activity?
    50 U/mg, from 2004\frac{200}{4}.
  6. Why are enzyme kinetic parameters estimated from initial rates?
    Early in the reaction substrate concentration is essentially unchanged, and product accumulation, reverse reaction and enzyme inactivation are negligible.
  7. What does a no-enzyme control measure in an enzyme assay?
    The background rate of nonenzymatic substrate conversion or signal drift, which is subtracted from the enzyme rate.
  8. Specific activity rises from 2 U/mg in the crude extract to 100 U/mg after a purification step. What is the fold purification?
    50-fold, from 1002\frac{100}{2}.
  9. In a coupled enzyme assay, why must the auxiliary enzyme be present in excess?
    So that the auxiliary step is never rate-limiting and the measured signal, such as NADH absorbance at 340 nm, reports the rate of the enzyme under study.
  10. In a valid initial-rate assay, what happens to the measured rate when enzyme concentration is doubled?
    It doubles. Rate should be directly proportional to enzyme concentration, so a nonlinear result signals an assay problem.
  11. Why is nonlinear regression to the Michaelis-Menten equation preferred over linear plots for estimating KmK_m and VmaxV_{max}?
    Linear transforms distort experimental error, giving heavy weight to the least reliable low-substrate points. Direct fitting weights the data properly.
  12. An assay gives Vmax=10V_{max} = 10 μM/s with a total enzyme concentration of 0.01 μM. What is kcatk_{cat}?
    1000 s−11000 \text{ s}^{-1}. kcat=Vmax[E]T=100.01k_{cat} = \frac{V_{max}}{[E]_T} = \frac{10}{0.01}.

Study these flashcards