Autodesk Fusion 360 Quiz
10 questions · no time limit
0:00
COMPONENTS AND ASSEMBLIES
Question 1 of 10
No time limit
Current
Answered
Flagged
Not seen
PASSAGE
A designer creates a revolute joint between a crank and a frame, then uses Drive Joint. The crank rotates as expected, but the frame also changes position relative to the design origin. No component in the assembly is grounded.
What should the designer do before using Drive Joint again to obtain a meaningful assembly-behavior test?
YOUR PROGRESS
10
QUESTIONS
Ready when you are
Answer in any order. Your progress shows here as you go.
QUESTIONS
KEYBOARD
Pick an answer ABCD
Next question ↵→
Previous ←
Flag for review F
Answers save as you go · flagged questions come back at the end