Autodesk Fusion 360 Quiz
10 questions · no time limit
0:00
COMPONENTS AND ASSEMBLIES
Question 1 of 10
No time limit
Current
Answered
Flagged
Not seen
PASSAGE
A hinged lid and its enclosure are included in a contact set, and contact solving is enabled. When the designer drags the lid, it still stops at a much smaller opening angle than expected. An angular joint limit is set to that smaller angle, before the lid would reach the enclosure.
What is the most likely reason the lid stops early?
YOUR PROGRESS
10
QUESTIONS
Ready when you are
Answer in any order. Your progress shows here as you go.
QUESTIONS
KEYBOARD
Pick an answer ABCD
Next question ↵→
Previous ←
Flag for review F
Answers save as you go · flagged questions come back at the end