01 / 21

Resistor-Capacitor
RC Circuits

Master the charging and discharging behavior of capacitors through resistors, including the time constant \(\tau = RC\) and exponential transient analysis.

AP Physics C: E&M

What Is an RC Circuit?

An RC circuit contains a resistor (\(R\)) and a capacitor (\(C\)) connected in series or parallel with a voltage source. When the circuit is switched on or off, the capacitor does not charge or discharge instantly: instead, it follows an exponential time-dependent behavior governed by the product \(RC\).

Resistor \(R\)
Opposes current flow. Measured in ohms (\(\Omega\)).
Capacitor \(C\)
Stores charge on parallel plates. Measured in farads (F).
Time Constant \(\tau\)
\(\tau = RC\), measured in seconds. Sets the pace of charging/discharging.

The Basic Series RC Circuit

+ − \(\mathcal{E}\) S \(R\) \(C\) \(i\)

Why RC Circuits Matter

RC circuits are everywhere in electronics and physics. Understanding them is essential for the AP Physics C: E&M exam and for real-world engineering applications.

Timing
Camera flashes, pacemakers, and clocks all use RC timing to create precise delays.
Filtering
Audio equalizers and signal processors use RC filters to pass or block specific frequencies.
Smoothing
Power supplies use RC circuits to smooth out voltage ripples from AC to DC conversion.

Kirchhoff's Loop Rule: Charging

Applying Kirchhoff's voltage law around the loop during charging:

Solving this first-order linear ODE with initial condition \(q(0) = 0\) gives the charge as a function of time:

Complete Charging Equations

Charge
$$q(t) = C\mathcal{E}\left(1 - e^{-t/\tau}\right)$$
Current
$$i(t) = \frac{\mathcal{E}}{R}\,e^{-t/\tau}$$
Voltage on C
$$V_C(t) = \mathcal{E}\left(1 - e^{-t/\tau}\right)$$

Charging Curves

Capacitor Discharging

When the battery is removed, the capacitor discharges. By Kirchhoff's loop rule, the potential drop across the resistor equals the potential across the capacitor:

The solutions for discharging (starting from \(q_0 = C\mathcal{E}\)):

Charge
$$q(t) = Q_0\,e^{-t/\tau}$$
Current
$$i(t) = \frac{Q_0}{RC}\,e^{-t/\tau}$$
Voltage
$$V_C(t) = V_0\,e^{-t/\tau}$$

Discharging Curves

Charging vs Discharging

Quantity Charging Discharging
Charge \(q(t)\) \(Q_{\max}(1-e^{-t/\tau})\) \(Q_0\,e^{-t/\tau}\)
Current \(i(t)\) \(\frac{\mathcal{E}}{R}\,e^{-t/\tau}\) \(\frac{Q_0}{RC}\,e^{-t/\tau}\)
Voltage \(V_C(t)\) \(\mathcal{E}(1-e^{-t/\tau})\) \(V_0\,e^{-t/\tau}\)
At \(t=0\) \(q=0,\; i=\mathcal{E}/R\) \(q=Q_0,\; i=Q_0/RC\)
As \(t\to\infty\) \(q=Q_{\max},\; i=0\) \(q=0,\; i=0\)

The Time Constant \(\tau = RC\)

The time constant \(\tau\) is the single most important parameter of an RC circuit. It tells you how fast the circuit responds.

1
At \(t = 1\tau\): capacitor reaches 63.2% of final value (charging) or falls to 36.8% (discharging).
2
At \(t = 2\tau\): reaches 86.5% (charging) or falls to 13.5% (discharging).
3
At \(t = 3\tau\): reaches 95.0%. At \(t = 5\tau\): reaches 99.3%, considered fully charged.
4
Units check: \([\Omega][\text{F}] = \frac{\text{V}}{\text{A}} \cdot \frac{\text{C}}{\text{V}} = \frac{\text{C}}{\text{A}} = \text{s}\). The product is indeed in seconds.

How to Solve RC Problems

1
Identify charging or discharging. Is the battery connected (charging) or disconnected (discharging)?
2
Find initial and final conditions. What are \(q\), \(i\), and \(V_C\) at \(t = 0\) and as \(t \to \infty\)?
3
Calculate \(\tau = RC\). Combine resistances and capacitances as needed for equivalent values.
4
Choose the correct formula. Plug into the appropriate charging or discharging equation.
5
Check limiting behavior. Verify your answer makes sense at \(t = 0\) and \(t \to \infty\).

Example 1: Charging a Capacitor

A \(5\,\text{k}\Omega\) resistor is connected in series with a \(10\,\mu\text{F}\) capacitor and a \(12\,\text{V}\) battery. Find the current and voltage across the capacitor at \(t = 25\,\text{ms}\).

1
Time constant: \(\tau = RC = (5000)(10 \times 10^{-6}) = 0.05\,\text{s} = 50\,\text{ms}\)
2
Current: \(i(25\,\text{ms}) = \frac{12}{5000}\,e^{-25/50} = 2.4 \times 10^{-3} \cdot e^{-0.5} \approx \) \(1.46\,\text{mA}\)
3
Voltage: \(V_C(25\,\text{ms}) = 12(1 - e^{-0.5}) = 12(1 - 0.607) \approx \) \(4.72\,\text{V}\)

Example 2: Discharging

A capacitor initially charged to \(V_0 = 9\,\text{V}\) discharges through a \(2\,\text{k}\Omega\) resistor. The capacitance is \(50\,\mu\text{F}\). How long until \(V_C = 1\,\text{V}\)?

1
Time constant: \(\tau = (2000)(50 \times 10^{-6}) = 0.1\,\text{s} = 100\,\text{ms}\)
2
Set up equation: \(1 = 9\,e^{-t/0.1}\)
3
Solve: \(e^{-t/0.1} = \frac{1}{9}\) so \(-\frac{t}{0.1} = \ln\!\left(\frac{1}{9}\right) = -\ln 9\)
4
Result: \(t = 0.1 \ln 9 \approx 0.1 \times 2.197 \approx \) \(0.22\,\text{s} = 220\,\text{ms}\)

Example 3: Energy in an RC Circuit

When charging a capacitor \(C\) from a battery \(\mathcal{E}\), how much energy is stored in the capacitor versus dissipated in the resistor?

Common Mistakes

✕ Wrong Formula Choice
Using \(1 - e^{-t/\tau}\) for discharging or \(e^{-t/\tau}\) for charging. Remember: charging grows toward a maximum, discharging decays toward zero.
✕ Forgetting Unit Conversions
Mixing \(\text{k}\Omega\) with \(\mu\text{F}\) without converting. Always convert to base units (\(\Omega\) and F) before computing \(\tau\).
✕ Confusing \(V_C\) and \(V_R\)
The voltage across the capacitor and the resistor are not the same. During charging: \(V_R = \mathcal{E} - V_C\). They add to \(\mathcal{E}\).

Question 1 of 5

An RC circuit has \(R = 4\,\text{k}\Omega\) and \(C = 25\,\mu\text{F}\). What is the time constant \(\tau\)?

Question 2 of 5

A capacitor is charging in an RC circuit. At \(t = \tau\), what fraction of the maximum charge has accumulated?

Question 3 of 5

A fully charged capacitor (\(V_0 = 20\,\text{V}\)) discharges through a resistor. After two time constants (\(t = 2\tau\)), the voltage across the capacitor is approximately:

Question 4 of 5

In a charging RC circuit, what happens to the current through the resistor as \(t \to \infty\)?

Question 5 of 5

When a battery charges a capacitor \(C\) to voltage \(\mathcal{E}\) through a resistor \(R\), the total energy dissipated in the resistor is: