01 / 21

Resistance, Resistivity
& Ohm's Law

Master the relationships between voltage, current, and resistance: from microscopic resistivity to macroscopic circuit behavior.

AP Physics C: E&M

What is Resistance?

Resistance is a material's opposition to the flow of electric current. When charges move through a conductor, they collide with lattice ions and impurities, losing kinetic energy. The greater the opposition, the less current flows for a given voltage.

\(R\)
\(I\)
+ −
\(V\)

What is Resistivity?

While resistance depends on the geometry of a particular conductor, resistivity (\(\rho\)) is an intrinsic property of the material itself. It quantifies how strongly a material opposes current at the microscopic level.

Resistivity \(\rho\)
Intrinsic to the material. Units: \(\Omega \cdot \text{m}\). Does not depend on shape or size.
Resistance \(R\)
Depends on material and geometry (length, cross-section). Units: \(\Omega\).

Why Resistance Matters

Understanding resistance is essential for designing circuits, power distribution systems, and electronic devices. It governs how energy is delivered, how heat is generated, and how signals are transmitted.

Power Dissipation
Resistors convert electrical energy to heat: \(P = I^2 R\). This powers heaters but also limits circuits.
Voltage Division
Resistors in series create predictable voltage drops, enabling sensor circuits and biasing.
Current Control
Choosing the right resistance ensures components receive safe operating current.

Ohm's Law: The Core Equation

The voltage across an ohmic conductor is directly proportional to the current through it:

\(I\)
\(V\)
Ohmic (constant R) Non-ohmic
\(\text{slope} = R\)
0

Resistance from Resistivity

\(L\)
\(A\)
\(I\)

Longer conductors have more resistance (more collisions). Wider cross-sections have less resistance (more paths for current). The material's resistivity \(\rho\) scales the effect.

Resistance vs Resistivity

Resistance \(R\) Resistivity \(\rho\)
Type of property Extrinsic (sample-dependent) Intrinsic (material-dependent)
Units \(\Omega\) \(\Omega \cdot \text{m}\)
Depends on geometry? Yes (length, area) No
Depends on temperature? Yes Yes
Relationship \(R = \rho\,L / A\)

Temperature Dependence

For most metals, resistivity increases approximately linearly with temperature near room temperature:

Metals
\(\alpha > 0\): resistance rises with temperature. Lattice vibrations scatter electrons more.
Semiconductors
\(\alpha < 0\): resistance falls with temperature. More carriers are thermally excited.

How to Apply These Laws

1
Identify the unknowns. Which of \(V\), \(I\), \(R\), \(\rho\), \(L\), \(A\) are you solving for?
2
Choose the right equation. Use \(V = IR\) for circuit problems; use \(R = \rho L/A\) when geometry or material properties are involved.
3
Check units. Convert lengths to meters, areas to \(\text{m}^2\), and currents to amperes before substituting.
4
Substitute and solve. Rearrange algebraically before plugging in numbers to minimize errors.
5
Sanity-check. Is your answer physically reasonable? A household wire should have \(R \ll 1\;\Omega\); a light-bulb filament ~ tens of ohms.

Example 1: Finding Current

A \(12\;\text{V}\) battery is connected across a \(4\;\Omega\) resistor. What current flows?

+ −
\(4\;\Omega\)
\(12\;\text{V}\)
\(I = ?\)

Example 2: Resistance from Geometry

A copper wire (\(\rho = 1.7 \times 10^{-8}\;\Omega\cdot\text{m}\)) is \(2\;\text{m}\) long with a circular cross-section of radius \(0.5\;\text{mm}\). Find its resistance.

1
Find the area: \(A = \pi r^2 = \pi(0.5 \times 10^{-3})^2 = 7.85 \times 10^{-7}\;\text{m}^2\)
2
Apply the formula: \(R = \rho\,L/A\)
3
Substitute: \(R = \dfrac{1.7 \times 10^{-8} \times 2}{7.85 \times 10^{-7}}\)
4
Result: \(R \approx\) \(0.043\;\Omega\) (about \(43\;\text{m}\Omega\))

Example 3: Doubling Dimensions

A wire of resistance \(R\) is stretched to twice its original length while keeping the total volume constant. What is the new resistance?

1
Volume is constant: \(V = LA = L'A'\). If \(L' = 2L\), then \(A' = A/2\).
2
New resistance: \(R' = \rho\,\dfrac{L'}{A'} = \rho\,\dfrac{2L}{A/2} = 4\,\rho\,\dfrac{L}{A} = 4R\)
3
Result: Resistance quadruples because \(R \propto L/A \propto L^2\) at constant volume.

Power Dissipation in Resistors

When current flows through a resistor, electrical energy is converted to thermal energy. Combining \(P = IV\) with Ohm's law gives three equivalent forms:

\(P = IV\)
General form: power equals current times voltage drop.
\(P = I^2R\)
Use when current is known. Dominant in series circuits.
\(P = V^2/R\)
Use when voltage is known. Dominant in parallel circuits.

The Microscopic Picture

At the atomic level, current arises from the drift of charge carriers. The current density \(\vec{J}\) relates to the electric field \(\vec{E}\) inside the conductor:

\(\vec{J}\)
Current density (A/m²): current per unit cross-sectional area.
\(\vec{E}\)
Electric field inside the conductor that drives charges forward.
\(\sigma\)
Conductivity: inverse of resistivity. High \(\sigma\) means easy current flow.

Common Mistakes to Avoid

✕ Confusing \(R\) and \(\rho\)
Resistance depends on geometry; resistivity does not. Don't swap their units (\(\Omega\) vs \(\Omega\cdot\text{m}\)).
✕ Forgetting Unit Conversions
Area in mm² must be converted to m² (\(1\;\text{mm}^2 = 10^{-6}\;\text{m}^2\)). This is the most common numerical error.
✕ Applying Ohm's Law to Non-Ohmic Devices
\(V = IR\) with constant \(R\) only works for ohmic materials. Diodes and transistors are not ohmic.

Key Equations Summary

Equation Formula When to Use
Ohm's Law \(V = IR\) Relate V, I, R in any ohmic element
Resistance from Geometry \(R = \rho\,L/A\) Finding R from material and shape
Current Density \(\vec{J} = \vec{E}/\rho\) Microscopic / field-based problems
Temperature Dependence \(\rho = \rho_0[1+\alpha(T-T_0)]\) Non-room-temperature problems
Power (three forms) \(P = IV = I^2R = V^2/R\) Energy dissipation in resistors

Question 1 of 5

A 9 V battery drives a current of 0.5 A through a resistor. What is the resistance?

Question 2 of 5

A wire of length \(L\) and cross-sectional area \(A\) has resistance \(R\). If both \(L\) and \(A\) are doubled, what is the new resistance?

Question 3 of 5

Which quantity is an intrinsic property of a material, independent of the sample's shape?

Question 4 of 5

A \(100\;\Omega\) resistor has \(2\;\text{A}\) flowing through it. What power does it dissipate?

Question 5 of 5

As the temperature of a copper wire increases, what happens to its resistance?