01 / 22

Induced Currents &
Magnetic Forces

Discover how changing magnetic flux creates currents, how Lenz's law determines their direction, and how induced currents experience forces that oppose the change.

AP Physics C: E&M

What Is Electromagnetic Induction?

When the magnetic flux through a conducting loop changes with time, an electromotive force (EMF) is induced in the loop. If the loop is part of a closed circuit, this EMF drives a current: an induced current.

\(\vec{B}\) \(I_{\text{ind}}\) Conducting Loop Changing flux induces current

Defining Magnetic Flux \(\Phi_B\)

Magnetic flux through a surface is defined as:

\(\vec{B}\)
Magnetic field strength (Tesla)
\(A\)
Area of the loop (\(\text{m}^2\))
\(\theta\)
Angle between \(\vec{B}\) and \(\hat{n}\)

Three Ways to Change Flux

Since \(\Phi_B = BA\cos\theta\), the flux changes if any of the three factors changes over time:

1
Change \(B\): Increase or decrease the magnetic field strength (e.g., moving a magnet closer or farther).
2
Change \(A\): Expand or shrink the loop area (e.g., a sliding rail on a track).
3
Change \(\theta\): Rotate the loop relative to the field (e.g., an AC generator spinning).

Faraday's Law of Induction

For a coil with \(N\) turns, each enclosing the same flux:

The negative sign is not just bookkeeping: it encodes Lenz's law, which tells us the direction of the induced current.

Lenz's Law: Nature Opposes Change

Flux Increasing X X X X X X \(I\) opposes: CCW (creates B out of page) \(\vec{B}_{\text{ind}}\) opposes increase Flux Decreasing X X X X X X \(I\) opposes: CW (creates B into page) \(\vec{B}_{\text{ind}}\) opposes decrease

Faraday vs Lenz: Key Distinction

Faraday's Law Lenz's Law
Tells you Magnitude of EMF Direction of induced current
Equation \(\mathcal{E} = -\dfrac{d\Phi_B}{dt}\) Encoded in the negative sign
Physical basis Changing flux creates EMF Conservation of energy
Key phrase "Rate of change of flux" "Opposes the change"

Forces on Induced Currents

Once an induced current \(I\) flows in a conductor sitting in a magnetic field \(\vec{B}\), that current-carrying conductor experiences a magnetic force:

By Lenz's law, this force always opposes the motion that caused the flux change. This is the origin of magnetic braking and eddy current damping.

The Sliding Rail Problem

\(R\) Bar \(v\) X X X X X X \(\vec{B}\) (into page) \(L\) \(I\) (induced)

Step-by-Step: Sliding Rail Solution

1
Flux: \(\Phi_B = B \cdot L \cdot x\), where \(x\) is the bar's position.
2
EMF (Faraday): \(\mathcal{E} = -\dfrac{d\Phi_B}{dt} = -BL\dfrac{dx}{dt} = -BLv\).
3
Induced current: \(I = \dfrac{|\mathcal{E}|}{R} = \dfrac{BLv}{R}\).
4
Direction (Lenz): Flux is increasing (into page), so current flows counterclockwise to oppose the increase.
5
Force on bar: \(F = BIL = \dfrac{B^2L^2v}{R}\), directed opposite to \(\vec{v}\) (braking).

How to Apply: General Method

1
Identify the loop: Which closed path are you analyzing? What is its area vector \(\hat{n}\)?
2
Write \(\Phi_B(t)\): Express the flux as a function of time: \(\Phi_B = BA\cos\theta\) with the changing variable explicit.
3
Differentiate: Compute \(\mathcal{E} = -\dfrac{d\Phi_B}{dt}\). Use the chain rule if multiple quantities vary.
4
Find current: \(I = \mathcal{E}/R\) for a resistive loop (or use Kirchhoff's rules for complex circuits).
5
Apply Lenz's law: Determine current direction by opposing the change in flux.
6
Compute forces: Use \(\vec{F} = I\vec{L} \times \vec{B}\) on each current-carrying segment.

Example 1: Changing Field

A circular loop of radius \(r = 0.10\;\text{m}\) sits in a magnetic field that increases uniformly from \(0\) to \(0.50\;\text{T}\) in \(0.20\;\text{s}\). The loop has resistance \(R = 5.0\;\Omega\). Find the induced current.

1
Area: \(A = \pi r^2 = \pi(0.10)^2 = 0.0314\;\text{m}^2\)
2
Rate of flux change: \(\dfrac{d\Phi_B}{dt} = A\dfrac{dB}{dt} = 0.0314 \times \dfrac{0.50}{0.20} = 0.0785\;\text{V}\)
3
EMF: \(|\mathcal{E}| = 0.0785\;\text{V} \approx 78.5\;\text{mV}\)
4
Current: \(I = \dfrac{0.0785}{5.0} = 0.0157\;\text{A} \approx 15.7\;\text{mA}\)

Example 2: Rotating Loop (Generator)

A rectangular coil of \(N = 100\) turns, area \(A = 0.04\;\text{m}^2\), rotates at \(\omega = 120\pi\;\text{rad/s}\) in a field \(B = 0.25\;\text{T}\). Find \(\mathcal{E}(t)\).

1
Flux: \(\Phi_B = BA\cos(\omega t) = (0.25)(0.04)\cos(120\pi t)\)
2
Faraday's law: \(\mathcal{E} = -N\dfrac{d\Phi_B}{dt} = NBA\omega\sin(\omega t)\)
3
Peak EMF: \(\mathcal{E}_0 = NBA\omega = 100 \times 0.25 \times 0.04 \times 120\pi \approx 377\;\text{V}\)

Example 3: Force & Power on a Sliding Bar

A bar slides at \(v = 3.0\;\text{m/s}\) on rails separated by \(L = 0.50\;\text{m}\), with \(B = 0.80\;\text{T}\) (into page) and \(R = 2.0\;\Omega\).

1
EMF: \(|\mathcal{E}| = BLv = 0.80 \times 0.50 \times 3.0 = 1.2\;\text{V}\)
2
Current: \(I = \dfrac{1.2}{2.0} = 0.60\;\text{A}\)
3
Braking force: \(F = BIL = 0.80 \times 0.60 \times 0.50 = 0.24\;\text{N}\) (opposes motion)
4
Power dissipated: \(P = I^2R = (0.60)^2 \times 2.0 = 0.72\;\text{W}\)
5
Check: \(P = Fv = 0.24 \times 3.0 = 0.72\;\text{W}\) ✓ Energy is conserved.

Eddy Currents and Applications

When a bulk conductor (not just a wire loop) moves through a non-uniform field, loops of current form inside the conductor. These are called eddy currents.

Magnetic Braking
Eddy currents in a metal plate produce forces that decelerate it: used in roller coasters and trains.
Induction Heating
\(I^2R\) losses from eddy currents heat conductors: the basis of induction cooktops.
Metal Detectors
A changing field induces eddy currents in hidden metal, which produce a detectable secondary field.

Common Mistakes to Avoid

✕ Confusing Flux with Field
A constant \(\vec{B}\) does not mean constant \(\Phi_B\). If the area or angle changes, flux changes even if \(B\) is constant.
✕ Wrong Lenz Direction
The current opposes the change in flux, not the flux itself. If flux is decreasing, the current supports the existing flux direction.
✕ Forgetting the \(N\) Factor
For a coil with \(N\) turns, the EMF is \(N\) times larger: \(\mathcal{E} = -N\dfrac{d\Phi_B}{dt}\). A single loop has \(N = 1\).

Summary of Key Equations

Quantity Equation Key Notes
Magnetic Flux \(\Phi_B = BA\cos\theta\) Units: Wb
Faraday's Law \(\mathcal{E} = -N\dfrac{d\Phi_B}{dt}\) Magnitude of EMF
Motional EMF \(\mathcal{E} = BLv\) Bar on rails
Induced Current \(I = \mathcal{E}/R\) Direction via Lenz
Force on Bar \(F = BIL = \dfrac{B^2L^2v}{R}\) Opposes motion
Power Dissipated \(P = I^2R = \dfrac{B^2L^2v^2}{R}\) Equals \(Fv\)

Question 1 of 5

A uniform magnetic field through a circular loop is increasing in magnitude. The loop is stationary. According to Lenz's law, the induced current will:

Question 2 of 5

A conducting bar slides at velocity \(v\) on frictionless rails in a uniform field \(B\) (into the page), with rail separation \(L\) and resistance \(R\). What is the magnitude of the braking force on the bar?

Question 3 of 5

A flat coil of \(N = 50\) turns and area \(A = 0.02\;\text{m}^2\) is in a magnetic field that changes from \(0.40\;\text{T}\) to \(0\) in \(0.10\;\text{s}\). What is the average induced EMF?

Question 4 of 5

In a sliding-rail circuit, doubling the velocity of the bar will cause the power dissipated in the resistor to:

Question 5 of 5

A magnet is dropped through a conducting ring. As it approaches the ring from above, the ring experiences a force that is: