01 / 20
+ −

Capacitors
Storing Electric Charge

Master the physics of capacitors: from the fundamental relation \( C = Q/V \) to energy storage, dielectrics, and series/parallel combinations.

AP Physics C: E&M

What Is a Capacitor?

A capacitor is a device that stores electric charge on two conductors separated by an insulator. When a voltage \( V \) is applied, charge \( +Q \) accumulates on one plate and \( -Q \) on the other, creating an electric field between them.

\(+Q\)
\(-Q\)
E field + − Parallel-Plate Capacitor

Why Do Capacitors Matter?

Energy Storage
Camera flashes, defibrillators, and power supplies rely on rapid energy release from charged capacitors.
Signal Filtering
Capacitors block DC and pass AC, making them essential in audio circuits, radios, and power conditioning.
Timing Circuits
RC time constants govern oscillators, clock circuits, and sensor debouncing in digital electronics.

The Capacitance Equation

For any capacitor, the fundamental definition is:

One farad equals one coulomb per volt. In practice, most capacitors are measured in \( \mu\text{F} \) (microfarads, \( 10^{-6} \, \text{F} \)), \( \text{nF} \) (nanofarads, \( 10^{-9} \, \text{F} \)), or \( \text{pF} \) (picofarads, \( 10^{-12} \, \text{F} \)).

Parallel-Plate Geometry

\(d\)
\(A\)
dielectric
constant \(\kappa\)
+ −

Energy Stored in a Capacitor

Work is done moving charge from one plate to the other. The total energy stored is:

\( \frac{1}{2}CV^2 \)
Best when you know capacitance and voltage directly.
\( \frac{Q^2}{2C} \)
Use when charge is given and voltage is unknown.
\( \frac{1}{2}QV \)
Convenient when both charge and voltage are known directly.

Series vs Parallel Capacitors

Series
\(C_1\)
\(C_2\)
Parallel
\(C_1\)
\(C_2\)
Same Q on each Voltages add Same V across each Charges add
Series Parallel
Equivalent \( C \) \( \dfrac{1}{C_{eq}} = \dfrac{1}{C_1} + \dfrac{1}{C_2} + \cdots \) \( C_{eq} = C_1 + C_2 + \cdots \)
Same quantity Charge \( Q \) Voltage \( V \)
Adds up Voltage \( V_{tot} = V_1 + V_2 \) Charge \( Q_{tot} = Q_1 + Q_2 \)
\( C_{eq} \) result Smaller than any single \( C \) Larger than any single \( C \)

Effect of Dielectrics

Inserting a dielectric material (an insulator) between the plates increases the capacitance by a factor \( \kappa \) (kappa), the dielectric constant. This happens because the dielectric's polarized molecules reduce the internal electric field.

Battery Connected
\( V \) stays constant. \( Q \) increases by \( \kappa \). Energy \( U \) increases.
Battery Disconnected
\( Q \) stays constant. \( V \) decreases by \( \kappa \). Energy \( U \) decreases.

Energy Density of the Electric Field

The energy stored in a capacitor can be understood as energy stored in the electric field between the plates. The energy per unit volume is:

How to Solve Capacitor Problems

1
Identify the configuration. Are capacitors in series, parallel, or a combination? Redraw the circuit if needed.
2
Find \( C_{eq} \). Use the series or parallel formulas to reduce the network to a single equivalent capacitor.
3
Find total \( Q \) or \( V \). Apply \( Q = C_{eq} V \) using the source voltage.
4
Back-substitute. Use the shared quantity (same \( Q \) in series, same \( V \) in parallel) to find individual charges and voltages.
5
Calculate energy. Use \( U = \frac{1}{2}CV^2 \) or \( U = \frac{Q^2}{2C} \) for each capacitor or the whole system.

Example 1: Parallel Combination

Two capacitors, \( C_1 = 3 \; \mu\text{F} \) and \( C_2 = 6 \; \mu\text{F} \), are connected in parallel across a \( 12 \; \text{V} \) battery. Find the total charge and energy stored.

Example 2: Series Combination

The same two capacitors (\( C_1 = 3 \; \mu\text{F} \), \( C_2 = 6 \; \mu\text{F} \)) are now connected in series across \( 12 \; \text{V} \). Find \( C_{eq} \), the charge on each, and the voltage across each.

Example 3: Dielectric Inserted

A parallel-plate capacitor has \( C_0 = 5 \; \mu\text{F} \) and is charged to \( V = 100 \; \text{V} \). The battery is then disconnected, and a dielectric with \( \kappa = 4 \) is inserted. Find the new voltage, charge, and energy.

Common Mistakes

✕ Swapping Series/Parallel Rules
Capacitors in series add reciprocally (like resistors in parallel). Do not add capacitances directly for series.
✕ Wrong Dielectric Scenario
Always check: is the battery connected or disconnected? The conserved quantity changes: \( V \) vs \( Q \).
✕ Forgetting the \( \frac{1}{2} \)
Energy is \( \frac{1}{2}CV^2 \), not \( CV^2 \). The factor of \( \frac{1}{2} \) comes from the integral \( \int_0^Q \frac{q}{C}\,dq \).

Capacitor Summary

Quantity Formula Key Notes
Capacitance \( C = Q/V \) Units: farads (F)
Parallel Plate \( C = \kappa \varepsilon_0 A/d \) \( \kappa = 1 \) for vacuum
Energy \( U = \frac{1}{2}CV^2 \) Also \( Q^2/2C \) or \( QV/2 \)
Energy Density \( u = \frac{1}{2}\varepsilon_0 E^2 \) General for any E field
Series \( 1/C_{eq} = \sum 1/C_i \) Same \( Q \), voltages add
Parallel \( C_{eq} = \sum C_i \) Same \( V \), charges add

Question 1 of 5

A \( 10 \; \mu\text{F} \) capacitor is charged to \( 20 \; \text{V} \). What is the energy stored?

Question 2 of 5

Three capacitors, each \( 12 \; \mu\text{F} \), are connected in series. What is \( C_{eq} \)?

Question 3 of 5

A parallel-plate capacitor is connected to a battery. A dielectric with \( \kappa = 3 \) is inserted while the battery remains connected. What happens to the charge on the plates?

Question 4 of 5

Two capacitors, \( C_1 = 2 \; \mu\text{F} \) and \( C_2 = 4 \; \mu\text{F} \), are in series across \( 18 \; \text{V} \). What is the voltage across \( C_1 \)?

Question 5 of 5

The plate area of a parallel-plate capacitor is doubled and the plate separation is halved. By what factor does the capacitance change?